How to install the Can-am Maverick X3 lower door panels

Introduction:

Can-Am Maverick X3 lower door panels can provide additional protection and comfort while riding off-road. Installing them is a straightforward process that can be done with basic tools. In this guide, we'll provide a step-by-step guide on how to install Can-Am Maverick X3 lower door panels.

Tools Needed:

1. Socket wrench set
2. Drill
3. Phillips screwdriver

Step 1: Remove the Stock Door Nets

Start by removing the stock door nets from your Can-Am Maverick X3. Use a socket wrench set to remove the bolts that hold the nets in place. Keep the bolts in a safe place, as you'll need them later.

Step 2: Prepare the Lower Door Panels

Take the Can-Am Maverick X3 lower door panels and remove any protective film or covers. Hold the panels up to the door frame to ensure they fit correctly. Use a marker to mark the locations where you'll need to drill holes for the mounting brackets.

Step 3: Mounting screws

Install the front door with Screws，nuts，and Washers，but do not fasten it.

Step 4:  Check for fit

Slide the door around and move it back and front for the door fits perfectly With the frame. （You can close the door to see if there is still a gap between the door and the frame to achieve a quick adjustment.）

Step 5: Tighten the screws

Snug up the nut on each of the three screws

Step 6: Install the other side door

Repeat the above steps for the other side of the vehicle.

Step 7: Test the Door Panels

With the Can-Am Maverick X3 lower door panels installed, test them to make sure they open and close smoothly. Check that they are aligned correctly and do not interfere with any other components of the vehicle.

Finally:  Enjoy Your New Lower Door Panels

Congratulations! You have successfully installed Can-Am Maverick X3 lower door panels. Enjoy the added protection and comfort they provide while riding off-road.